I have a 4006 Switch with an Access Gateway Module, in that AGM i have a 8-Port RJ21 FXS Module. I can connect an analog phone to this module and assign a dial peer for this phone. From a VoIP phone I cal call this analog phone, but when I pick up the analog phone I get dial tone, but when I call out this phone tries to call directly out one of my FXO ports. Any suggestions?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.