Hi I have operators working in 5 different locations each with local access numbers, some with overlapping.
We need a solution that can help then since we are upgrading from CUCM 6.1.3 that had a attendant console to 8.5.1 that needs a separated server.
By first we were recommended to use Enterprise since we can expand from the 9 operators that are working at the same time, but the instalation of the trial for the Enterprise seems to cause more problems than solve since I can't separate cti port groups to each queue, and for the operator to fully function they need to have separated CSS to allow exit through the correct location even more for blind transfers.
You are correct, today the product only uses a single pool of CTI Ports in the system, this does mean you have to use the same CSS/PTN/MoH for all the queues and operators.
In version 9 (due for release in June) it will be possible to create multiple pools of devices and associate these to queue(s), this will allow the configuration you are after.
In the meantime, there is actually a way to by pass the use of CTI Ports when performing a blind transfer called direct transfers, you can enable this on the Operators PC and what it does is redirect the call from the orginating device (voice gateway) and will therefore use the CSS of that device and therefore achieve what you are after.
The "downside" of using this is that it removes the feature of recalling calls if the transfer goes unanswered, this is because CUEAC is not able to monitor the call once the redirect has taken place.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...