Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Help with H.323 setup

Hi,

I'm trying to put to work a small voip setup compossed of CCM 5.0 server and a 2821 with a VIC2-2BRI card as TE (user side) and IOS 12.4(10) but its's not working when it comes to call or receive calls from the PSTN/PBX. It seems that the Route Pattern configured in Call Manager doesn't find the gateway and

viceversa. Furthermore I'm not sure whether dial peers are working. Im' using H.323 although previously I tried MGCP also.

When I call from the IP phone no call arrives to the gateway and when I call from the pbx the call does reach the gateway but not the ip phone. The gateway looks unregister in Call manager but i think this is normal in H.323, not sure.

I attach the diagram of my setup. This is the relevan part of my configuration.

Dial-peer voice 1 pots

incoming called-number 6....

direct-inward-dial

dial-peer voice 2 voip

destination-pattern 6...

session target ipv4:10.10.5.1

no digit-strip

dial-peer voice 3 pots

destination-pattern 9...

port 0/0/1

no digit-strip

gateway

int G0/1

ip address 10.10.5.2 255.255.255.0

h323-gateway voip interface

h323-gateway voip bind srcaddr 10.10.5.2

interface BRI0/0/1

no ip address

isdn switch-type basic-net3

isdn protocol-emulate user

isdn layer1-emulate user

isdn incoming-voice voice

1 REPLY
Bronze

Re: Help with H.323 setup

You need to provide the gateway address in the Callmanager gateway configuration. Make sure that gateway is configured correctly.

http://cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094636.shtml

112
Views
0
Helpful
1
Replies
CreatePlease login to create content