Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

Help with NM2V/E&M and a 2651

Hello all,

I just installed a NM2V with a VIC2-2EM into a 2651 router. I can't for the life of me get the router to recognize the boards. I've tried a few IOS versions (12.2 8T5) and (c2600-ipvoice-mz.123-4.T4.bin) which was recommended by our SE. Neither work.

Any quick suggestions. Is this hardware not supported on the 2651? Do I have to have a specific IOS? I'm at a loss here.

Anything is appreciated!

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Help with NM2V/E&M and a 2651

This NM-2V HW is supported in the release/platform you're using, but you cannot use a VIC2 card in an Nm-2V. The NM-2V supports only the older generation VIC- cards. And the new generation NM-HD-1V/2V supports the VIC2- cards. Check the datasheets for details of the lists of equipment supported.

2 REPLIES
New Member

Re: Help with NM2V/E&M and a 2651

This NM-2V HW is supported in the release/platform you're using, but you cannot use a VIC2 card in an Nm-2V. The NM-2V supports only the older generation VIC- cards. And the new generation NM-HD-1V/2V supports the VIC2- cards. Check the datasheets for details of the lists of equipment supported.

Bronze

Re: Help with NM2V/E&M and a 2651

Christina,

100 percent on the money. Kudos.

I have shipped out VIC-2E/M cards to the customer. I do appreciate the reply. That saved me a ton of grief ;)

114
Views
0
Helpful
2
Replies
CreatePlease to create content