We are getting an error on our Nortel PBX (PRI254) when users call our remote sites going from a tandem PBX site.
"Database error: The DCH is interfacing with a software issue not supported by the application."
Action: "Verify that the release ID in the configuration record is the same as the software release running on the far end switch."
The only time it happens is when someone from another PBX site dials a remote site extension that has to go through a Cisco 7206. We have the Route from the 7206 to the PBX built as SL100 and the routes from PBX to PBX are built as DMS-100. Here lies the issue I believe. Has anyone cleared this issue? How?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...