Hidden commands in voice class mode

[lomine]

Hello all...

I have 2610 router with IP Plus 12.1(5)T10 IOS, and the fxo disconnect problem is ocurring. I have already got the tone frequency and caddence for my contry (Brazil), but i don't know how to use the hiddem commands "freq-max-on, freq-min-off, caddence-xxxxxxx". What are the options ( values) used with these commands and for what should I use these commands ?

Tks.

[ssoberlik · Accepted solution]

The following URL has information on fxo disconnect problem and to configure the "freq-max-on, freq-min-off, caddence-xxxxxxx".

Globalized Cadence and Tone for Cisco IOS Gateways

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t11/ft_glbl.htm

The cadence configuration commands are visible in Cisco IOS Release 12.1(3)T; however, they are not implemented in the Cisco IOS Release 12.1(3)T software. Support for cadence detection is available in the FXO Answer and Disconnect Supervision feature in Cisco IOS Release 12.2(2)T. This allows detection of tones in custom cadence patterns with up to four on/off time cycles.

FXO Supervisory Disconnect Tone

http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/products_feature_guide09186a00800801d1.html#61592

FXO Answer and Disconnect Supervision

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080087b4f.html#131088