I bought Cisco HIDS when I got my call managers and had to reinstall them between then and now so HIDS is currently not on the CMs.
I was wondering whether it would be preferable to have the HIDS console off the CMs as opposed to on the Publisher. The company that installed my CMs installed the Console on the Publisher - but after taking some CIPT courses I was thinking that might not be the best idea.
Any opinions on this? I suppose I could install the Console on another unit and install the 3 WWW licenses I have on the Pub, Sub, and Unity boxes..
I think you are on the right track by moving the console off of the publisher. Although we don't use the HIDS on our CCMs, a couple of our customers have reported problems with the console locking up if there are too many alarms, which can happen if the HIDS is not finely tuned.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...