Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Hoe do I configure a voice T1 on 2811

How do I configure a voice T1 on a 2811 with callmanager 4.1, is it setup in the mgcp gateway, or do ii have to configure manually, DS0-group?

4 REPLIES
Super Bronze

Re: Hoe do I configure a voice T1 on 2811

Hi

Try following this:

http://www.cisco.com/en/US/tech/tk1077/technologies_configuration_example09186a00801ad22f.shtml

It's for an older version of CM but should work OK, the config-download command will download updated settings once it's registered...

Post back if you have problems...

Regards

Aaron

Please rate helpful posts..

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
Community Member

Re: Hoe do I configure a voice T1 on 2811

The problem is that it is a long distance voice T1 not a PRI...

Super Bronze

Re: Hoe do I configure a voice T1 on 2811

What protocol does the circuit run? I'm not sure I understand how you are differentiating between the two.

T1 is the actual circuit type, PRI is the protocol that runs over it... over here in the UK we have E1 PRIs.

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
Community Member

Re: Hoe do I configure a voice T1 on 2811

not sure, they said it was a voice T1 not a PRI. is it configured with the ds0-group command and not the pri-group command?

156
Views
0
Helpful
4
Replies
CreatePlease to create content