Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Hold doesn't work with calls via Gatekeepr

Hi,

I have a CME and CM via a gatekeeper.

Both can call each other via gatekeepr or PSTN.

If PSTN call was initiated first, I can still make another call via GK while put PSTN call on-hold.

But, if call via GK was established first, can't put the call on hold to mak/answer new call.

This only happen with phones on CM.

Any idea?

Thanks,

Everyone's tags (1)
2 REPLIES

Re: Hold doesn't work with calls via Gatekeepr

In CUCM admin, on the trunk to the gatekeeper, check "Media Termination Point required" and make sure there is an MTP in a Media Resource Group available to this trunk.

Hope this helps.

Brandon

New Member

Re: Hold doesn't work with calls via Gatekeepr

Hi Brandon,

Box was checked because the instruction I used suggested as well.

Just out of curiosity, I did unchecked and now it works fine.

Not sure what is going on.

I have CUCM 7 and CME 7.

Thanks,

375
Views
0
Helpful
2
Replies