The configurations are exactly the same, the issue here is that when I press the "flash" key, the cisco recognized as hung-up, so I think there is something wrong with the hookflash timing, but I have change it to many values on each site, and it does not work.
The ciscos are 1750s, the PBX (Switch) is Nortel DMS-100 and the telephones are Panasonic KX-T2315.
Has anybody has done this before? any recommendations?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...