Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

hosting CCME and CUE in separate voice gateway

How do you configure ccme to interoperate with cue in separate device? Do you configure dial-peer for voicemail using sip on the ccme and point it to the cue address in the other router? What about MWI? Any configuration would help.

1 REPLY

Re: hosting CCME and CUE in separate voice gateway

IPPhone---CME--------RouterwithCUE.

You can set up h323 dial-peers on the CME gateway and then point it to the router which has CUE installed. (vice versa). Make sure you give the following command in the RouterwithCUE.

voice service voip

allow-connection h323 to sip

allow-connection sip to h323

On the dial-peers you should use codec g711ulaw. If you use g729 then you will need to setup transcoders to transcode the g729 call before sending it to CUE.

Also you need to set up dial-peers for the MWI numbers (8000.... and 8001....) from the router that hosts CUE back to the CME Router.

HTH

Sankar

PS: please remember to rate posts!

109
Views
0
Helpful
1
Replies