Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

HotDial on 7912G

I'm trying to perform hotdial on the IP phone 7912G.

My test environment:

- Callmanager 4.1.(3)

- Two IP phones 7912G. One has directory number 5000, another one 5001.

My task is to perform Hotdial from 5001 to 5000.

As described in the document stored on the URL http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080232b9f.shtml

I tried to setup phone 5001 as a PLAR phone.

- I created Partition

- I created CSS which includes previously created partition

- I created Translation pattern with ?Called party Transform Mask? equal to 5000.

- I associated phone 5001 with CSS

But when phone 5001 goes off-hook -- nothing happens!

How can I verify or debug my configuration?

2 REPLIES
Hall of Fame Super Red

Re: HotDial on 7912G

Hi Maxim,

Check in the Translation Pattern config that you used the new Partition and new CSS. Also ensure that under the Translation Pattern > Route Option that you have checked the "Route this pattern" area.

Hope this helps!

Rob

Please remember to rate helpful posts........

New Member

Re: HotDial on 7912G

Thank you. But I carefully checked configuration. Everyhing was OK.

I've rebooted Callmanager Server and it works!

103
Views
0
Helpful
2
Replies