Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How can I configure in a FXO port which only one specific IP phone can dial out this port?

In a AVVID network: a CCM, 5 C7960 and one VG200 with a T1 CAS to PBX.

I configured the port 1/0:0 as FXO as extension 6003 and configure the connection plar 6001(IP Phone), so when make a call from PBX to 6003, the call will auto-ring to 6001.

and I also need only allow 6001(IP phone ) to use this FXO port, all others IP phone can't use this FXO,

Please point me how to configure.

1 REPLY
Anonymous
N/A

Re: How can I configure in a FXO port which only one specific IP

Not knowing the entire dial-plan, it's hard to pin point.

You can do several things on the call manager, specify calling space. and patition etc.

One simple thing you can try is

on the Vg200, specify a voip dial-peer as following:

dial-peer voice 100 voip

desttination-pattern 6001

incoming called-number 6003

session target ipv4:( call-manager ipadd)

227
Views
0
Helpful
1
Replies
CreatePlease login to create content