How can I get a VOIP point to point PLAR to work from an FXS card to a PRI T1 DS0?
We have a lab set up with 2 3660 routers loaded with 12.2(6.7). We are trying to get a PLAR circuit to work with an FXS card on 1 going to a PRI T1 DS0 on the other. They are both set for
connection plar. We are able to ping both ways. Dial peers for voip and pots are correct, but the PRI T1 side phone will not go off hook and ring the FXS side. When going off hook on the FXS side, you get ring back, but the PRI T1 side does not ring. Can someone please help?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.