Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How can i send faxes with ata?

Hi, this is my scenario:

- Ata186 connected to common fax.

- A dial peer voice voip on gateway

- Command voice service voip on gw

I`ve observed that when i tried to make a call with a analog telephono commanda sh isdn actice dont show this call.

Any ideas??

Thanks

1 REPLY
Blue

Re: How can i send faxes with ata?

just to be sure your ATA and IOS configuration are correct, please see the following link for ATA configuration/troubleshooting:

http://www.cisco.com/en/US/partner/products/hw/gatecont/ps514/products_configuration_example09186a00800d698e.shtml

also, when trying to view IOS for active ISDN calls, it is also advantages to debug on q931 to see the real time operation of the router and ISDN protocol as the call is setup/torndown.

you can use the 'debug isdn q931' command to invoke this debug.

117
Views
0
Helpful
1
Replies
CreatePlease to create content