I'm not sure what you mean by endpoint (just phones, or CallManagers/media servers etc), and in what context of application development (XML applications for IP Phones?).
Device name is a safe bet for uniquely identifying devices within a CallManager cluster. The phone can send it's name when requesting an XML service, and you can also use DeviceListX to look up device information for phones.
A list of devices configured for the cluster can be found in the device table of the CCM030x table (where x is a number, incrementing by one each time you upgrade the CallManager). I wouldn't necessarily suggest reading this table at run-time, but point it out so that you can see a list of devices during development and know what to expect.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...