How can we return to DC Directory after integrating with AD?

[francois.champagne]

After integrating Callmanagers to Active Directory (1000 users), how can we return to DC Directory?

Is there any tools to disable AD, Renable DC Directory and migrate the users from AD to DC?

Or we have to ReInstall the CallManager and after use some tools to migrate the users?

Thanks

[Brandon Buffin]

The following link describes how to revert to using DC Directory. It does not, however, discuss how to move user information. The procedure does not require a reinstallation of Callmanager.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00800ab82d.shtml

The following post which describes a way to move information from DC Directory to AD may be of interest.

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=IP%20Communications%20and%20Video&topic=General&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1dd6109e/0#selected_message

Hope this helps. If so, please rate the post.

Brandon

[simon.draper]

Hi,

we have the same issue, we'd like to get a best practices document or at least some possible gotchas from anyone else who has done this.

thanks.