How do I know what type of NM installed in the router?
In the router, for example 3725, how do I know what type of NM-HD module installed without physically look the hardware? is there any command to check? especially in the case of configure MGCP the router remotely.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.