how do I start with 1xB channel and activate more channels if required.
For a VoIP project, I am building a network and since the customer's voice is very important they asked me to have a backup E1 connection as well. what I am planning is having a E1-PRI card on each router that connected to the PSTN and then create a floating static route for DDR. If the main route disappears, DDR will kick in and establish the connectivity.
My question is; how do I start with 1xB channel and activate more channels if required. I don't want whole E1 to make a call via 30 channel for one VoIP call. however, if more calls comes and load on a B channel goes up to %75 then I want second one to dial. if more traffic comes then the 3rd one 4th one etc.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.