We have been trying to troubleshoot transcoding resources and have had no luck. We think it is because the server is able to transcode to G.729a natively. In 4.01, there is no way to disable it that we have seen. Anyone have any input?
When the registry setting HKEY_LOCAL_MACHINE\Software\Active Voice\AVSkinny\G729 Enabled is set to 1, it means that Cisco Unity is capable of receiving both G.729a streams and G.711 streams. It does not indicate that G.729a is in use for message storage. This is the default setting for Cisco Unity version 3.1(x) systems. Because the G.729a codec is installed automatically with version 4.0(1) and later, this registry setting is no longer needed
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...