I've got my main campus and a remote site connected by an encrypted GRE tunnel. Where do I place de QOS pre classify command, on the tunnel interface or on the crypto-map...or on both.
I've tried configuring it on both. On the policing policy-map on the outgoing interface, my match statement is an ACL trying to match on ESP traffic (the hit counter doesnt increase) and I've added a line for the un-encrypted trafic IPs and this one has hits. In the child policy, I've got hit with my IP precedende value in my voice class, that part is ok.
So, why can't I match on my permit ESP host A host B? And how is it possible to have match on the acl (permit ip any to remote site range)? The later should be encrypted when it hit the outbound policy map.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...