i'm using cisco 1751 for connecting two sites through international leased circult. i'm using 4 voice channels for communication between two sites. i'm wondering if there is a command for checking the utilization of the wan link so i can decide if i want to upgrade the international leased circuit or not.
you know, international circuit is expensive so paying for higher bandwidth needed to be careful.
use the load interval command to reduce the delay and after that you can see with a show interface command what's the load on the interface. For sure this will not give you an overall view. You have to determine the total BW required by you voice call and be sure that the total bandwidth used by voice and data never exceed 75% of the line rate of the link.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.