I have a question on voice gateway R2800 router with CCM 4.1. If under H323 GW, we can easily check the called number by command "show voice call status". However, under MGCP GW, what command I can input such that I can know what the exact calling/called number processed by the MGCP GW. (in my understanding, I can only use "debug isdn q931" to check the number). Any other way that I can check the numbers?
<<by using H323 GW>>
HKVG2811#sh voice call status
CallID CID ccVdb Port DSP/Ch Called # Codec Dial-peers
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...