01-10-2002 04:42 AM - edited 03-12-2019 01:59 PM
I have AS5300 with 120 DSP channels. How to check that all of DSPs are in good condition.
01-14-2002 02:10 PM
Have you tried SHOW VOICE DSP?
01-14-2002 06:50 PM
Halo Rokibbe,
Thanks for your reply.
I tried:
jkt-gtw10>en
Password:
jkt-gtw10#sh voice ?
busyout Show all configured busyout
call Show all or one voice port call status
dsp Show all dsp status
port Show all or one voice port configuration
trace Show call trace info about specified port
jkt-gtw10#sh voice
% Incomplete command.
jkt-gtw10#sh voice dsp ?
| Output modifiers
jkt-gtw10#sh voice dsp
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT
==== === == ======== ======= ===== ======= === == ========= == ===== ===========
=
jkt-gtw10#sh voice dsp
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT
==== === == ======== ======= ===== ======= === == ========= == ===== ===========
=
jkt-gtw10#
How to know the DSP is good?
Regards,
Ronald.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide