Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to check the condition of DSP in AS5300

I have AS5300 with 120 DSP channels. How to check that all of DSPs are in good condition.

2 REPLIES
New Member

Re: How to check the condition of DSP in AS5300

Have you tried SHOW VOICE DSP?

New Member

Re: How to check the condition of DSP in AS5300

Halo Rokibbe,

Thanks for your reply.

I tried:

jkt-gtw10>en

Password:

jkt-gtw10#sh voice ?

busyout Show all configured busyout

call Show all or one voice port call status

dsp Show all dsp status

port Show all or one voice port configuration

trace Show call trace info about specified port

jkt-gtw10#sh voice

% Incomplete command.

jkt-gtw10#sh voice dsp ?

| Output modifiers

jkt-gtw10#sh voice dsp

DSP DSP DSPWARE CURR BOOT PAK TX/RX

TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT

==== === == ======== ======= ===== ======= === == ========= == ===== ===========

=

jkt-gtw10#sh voice dsp

DSP DSP DSPWARE CURR BOOT PAK TX/RX

TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT

==== === == ======== ======= ===== ======= === == ========= == ===== ===========

=

jkt-gtw10#

How to know the DSP is good?

Regards,

Ronald.

147
Views
0
Helpful
2
Replies
CreatePlease to create content