How to configure the bundle ISDNs for voice calls using one pilot No.
One company has 3 ISDNs connected to its PBX for customer service. Each B-chanel has one DID number, and use the first No. as the pilot No. In the PBX enviornment, the 3 ISDNs can works fine. The company's customer can have 6 calls to the Pilot No. at the same time.
Now the company wants to move this environment to Cisco IPT. Use 2 VIC-2B-NT/TE for the three ISDNs on Cisco 1751 router as the voice gateway. I found I can only dial two calls of the Pilot No. If I have the 3rd call, I can only have the no-answering tone.
And on the gateway, I use "Debug isdn q931", I did not find any traffic coming in.
Is there any specific configuration on voice gateway for the bundle of ISDNs?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...