Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

how to configure the cisco routers to the sip gateway ?

I used two 1750s as the sip gateways and connected the 2 phones on the fxs ports. In the 1750, I configured the following in one 1750. is it correct ?

phone--1750----ethernet-----1750--phone.

=======================================

dial-peer voice 1 voip

destination-pattern 1.

session protocol sipv2

session target ipv4:10.1.1.1(ip of another 1750)

dial-p voice 2 pots

destination-pattern 20

port 1/0

=======================================

1 REPLY
Anonymous
N/A

Re: how to configure the cisco routers to the sip gateway ?

whats the problem with your config. It look ok

to me except you must add a clock timezone in

config mode.

"clock timezone GMT -9 "

without this command the sip signalling wll not work.

250
Views
0
Helpful
1
Replies
CreatePlease to create content