Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to configure the cisco routers to the sip gateway ?

I used two 1750s as the sip gateways and connected the 2 phones on the fxs ports. In the 1750, I configured the following in one 1750. is it correct ?

phone--1750----ethernet-----1750--phone.

=======================================

dial-peer voice 1 voip

destination-pattern 1.

session protocol sipv2

session target ipv4:10.1.1.1(ip of another 1750)

dial-p voice 2 pots

destination-pattern 20

port 1/0

=======================================

  • Other Collaboration Voice and Video Subjects
1 REPLY
Anonymous
N/A

Re: how to configure the cisco routers to the sip gateway ?

whats the problem with your config. It look ok

to me except you must add a clock timezone in

config mode.

"clock timezone GMT -9 "

without this command the sip signalling wll not work.

112
Views
0
Helpful
1
Replies