How to cut off handpiece audio when using a headset?
We have 7941s and 7961s using various (mostly GN Netcom) headsets plugged into the headset jack (i.e. not using lifters, etc). When the headset is active, the audio still comes through the handpiece speaker.
This is a problem for the clients when they are conducting consultations and the customer can hear the phone conversation through the handpiece speaker which is still on hook.
Is there a way to turn off the handpiece audio when using a headset, or is this the default behaviour?
We are running CM 6.1(2) and 7941s are running code 8.3.4.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...