Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to dial a # on callmanager

I need to modify a called number in a route or translation pattern to send the dtmf tone of # and then pause for 3 sec, any thoughts.

3 REPLIES
New Member

Re: How to dial a # on callmanager

you can modify the digits in the route pattern but at this time you can not add a pause.

hope this helps

scott

New Member

Re: How to dial a # on callmanager

but # in the paterns means end of the number i need to send the dtmf tone of #

Silver

Re: How to dial a # on callmanager

There is a callmanager service parameter "Strip # Sign From Called Party Number".I guess if you set it to false the number will be send as it is

Strip # Sign From Called Party Number : This parameter enables the stripping of # sign digits from the called party IE for the inbound, outbound Q.931, and H.225 SETUP messages.

This is a required field.

Default: true.

148
Views
0
Helpful
3
Replies
CreatePlease to create content