Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to emulate PBX connection?

Dear Sir!

In our lab we need to emulate pbx connectivity to test trunks configuration.

Suppose, we have such scheme:

R1(as PBX)--(E1trunk)--R2--(network: IP/FR/ATM)--R3--(E1trunk)--R4(as PBX)

and there are analog phones, connected to FXS ports in R1 & R2.

Q: How can we used our NM-HDV's with VWIC-1MFT-E1's for such E1

back-to-back configuration (i.e. configuration example)?

Best regards,

Nick

1 REPLY
Silver

Re: How to emulate PBX connection?

The following document has a similar configuration.It could help you in this regard.

Master and Slave Relationships on a T1 Back-to-Back Connection

http://www.cisco.com/en/US/tech/tk713/tk584/technologies_configuration_example09186a00800a6b82.shtml

Configuring 1- and 2-Port T1/E1 Multiflex Voice/WAN Interface Cards on Cisco 2600 and 3600 Series Routers

http://www.cisco.com/en/US/products/sw/iosswrel/ps1830/products_feature_guide09186a0080087b21.html

205
Views
0
Helpful
1
Replies