I have 4 users that need access to the corporate PBX system. The users are located in a remote office that is connected to corporate via a point-to-point T1. I would like to setup 4 handsets at the remote office that connect to the corp PBX. It seems like the cheapest way I see of doing this is to use two 1751 routers with 4 voice ports each. This is still rather expensive. Are there other alternatives? If I use Cisco IP phones how would I connect them to the PBX? If I use the IOS routers where can I find a sample config for a setup such as this?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...