Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to force "dp voice 1 voip" to always use a certain "dp voice 4 pots"

Using ISDN PRI with AS5350 (4 channels: ports 0 - 3)

Configuration:

!

dial-peer voice 1 pots

destination-pattern .....

no digit-strip

direct-inward-dial

port 3/0:D

forward-digits all

!

dial-peer voice 2 pots

destination-pattern .....

no digit-strip

direct-inward-dial

port 3/1:D

forward-digits all

!

dial-peer voice 3 voip

destination-pattern 1234

session target ipv4:192.168.20.2

codec g729br8 bytes 50

!

dial-peer voice 4 voip

destination-pattern 5678

session target ipv4:192.168.21.2

codec g729br8 bytes 50

!

QUESTION:

If I use a phone behind dialpeer 3 voip, with trunking, the call will go to pots 1 or 2, depending on load of pots.

However, I want to force any call being made behind dialpeer 3 voip, to always go to dialpeer 2 pots, independent of the dialing number (destination-pattern).

Another way to look at it, using a specific phone, I always want to end up using port 2 of AS5350.

Any ideas?

~J.K.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: How to force "dp voice 1 voip" to always use a certain "dp v

I think The Class of Restrictions (COR) feature could help you.

More information you can find here

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/vvfax_c/int_c/dpeer_c/dp_confg.htm#wp1069133

Please rate usefull posts

3 REPLIES
Bronze

Re: How to force "dp voice 1 voip" to always use a certain "dp v

just a thought,

couldnt you use the preference command and give 2 the higher preference?

New Member

Re: How to force "dp voice 1 voip" to always use a certain "dp v

Could work, but I don't want to affect any other lines.

If I have 100 phones & 4 ISDN lines, I want to force the following, for example:

Phones...01-20.....Port 0....20 Phones

Phones...21-40.....Port 1....20 Phones

Phones...41-90.....Port 2....50 Phones

Phones...91-100....Port 3....10 Phones

So how would I force phones 1-20 to always go to Port 0, phones 21-40 to always go to Port 1... and so on ? And each phone should be able to dial any number they want.

~J.K.

New Member

Re: How to force "dp voice 1 voip" to always use a certain "dp v

I think The Class of Restrictions (COR) feature could help you.

More information you can find here

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/vvfax_c/int_c/dpeer_c/dp_confg.htm#wp1069133

Please rate usefull posts

107
Views
0
Helpful
3
Replies
CreatePlease to create content