I have CallManager 4.2 and I want to make call reject functionality when the phone is on-hook and ringing. There is only answear and iDivert softkeys in this mode. It is possible to make iDivert to invalid number but I'm looking for more elegant solution.
If so it could be possible to idevert to a service that disconnects the call and does not actually answer or give busy tone. Howeve depending on the network, that may have the same effect to the caller.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...