Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to match a dial-peer based on the calling number

I want to mask a specific extension with a specific clid. Anyone know how I match a dialpeer based on the calling number as opposed to the destination pattern??

2 REPLIES
Bronze

Re: how to match a dial-peer based on the calling number

the call is always using 2 dial-peers for call setup, inbound and outbound.

inbound dial-peer matching has this order:

1. DNIS with incoming called-number

2. ANI with answer-address

3. ANI with destination-pattern

4. voice-port - for inbound POTS calls only

5. dial-peer 0 (default dial-peer)

outbound dial-peer uses destination-pattern for matching.

so if you are dialing 1000 from 2000 you would have something like this

dial-peer voice 1 voip

answer-address 2000

direct-inward dial

dial-peer voice 2 voip

destination-pattern 1000

session-target ras

read here for more details http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

New Member

Re: how to match a dial-peer based on the calling number

Thanks for this - really helped, great document - has been added to my bookmarks!

1047
Views
0
Helpful
2
Replies