how to provision voice, video and data traffic over the E1 line?

[paulnigel]

Hi forum,

How do I configure my qos given the below scenario, the traffic will run trough E1 lines:

1) i have the most 4 sites communicate using video over ip (30fps).

2) my existing voip is using 512kbps

3) data too

I understand that the combined bandwidth for voice and video should not exceed 33%. How should this be done?

Thanks much,

paul

[Tim Smith]

Hi There,

My best suggestion would be to read the design guide below:

http://www.cisco.com/application/pdf/en/us/guest/netsol/ns432/c649/ccmigration_09186a008049b062.pdf

Have a crack at the config using LLQ and if you have problems, post the config here so we can see.

Cheers,

Tim.

[paulnigel]

wow! that's a long one. i will go through this. Thanks Tim.