Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to reduce the time to get dial tone after trunk access in a Cisco 1760?

I have a central node with a 1760-V, in other two remote sites have 1751-V and 1750-V.

Problem is after I access the extension in central node I receive tone, then dial the remote pot, it takes around 15 to 20 seconds to receive the ringback.

I tried to configure interdigit option in voice ports, handle it in 5, 2 and 0 values but didn´t have a good result.

Is there another parameter I could handle to improve the response time?

I am using version c1700-sv8y-mz.1222-8.T5.bin in central node.

1 REPLY
Silver

Re: How to reduce the time to get dial tone after trunk access i

Start with taking a look at network performance:

http://www.cisco.com/warp/public/126/perfmgmt.htm

93
Views
0
Helpful
1
Replies