When I place a call to PSTN always on destination station (mobile or isdn phone) I can see either default ID of PRI or ID which belongs the range of allocated ID for this PRI. Even I can see that 'deb isdn q93' sending 0000 as Calling ID on the destination unit default ID shows. The engineers from our telecom indeed that is no restrictions from their side and that is just a enabling CLIR matter. I can't find what is the CLIR actually doing on ISDN level. Could you help with detailed description? By the way this problem I having in Cyprus and most probably we using euro-ISDN standard.
My question about other case when c5300 initiate the POT leg. Even I send fake or empty calling ID I still can't hide default PRI ID. I looking for the instrustion how to hide my PRI line number while I calling to mobile or other ISDN end points.
Unfortunately they don't have a clue how to configure Cisco Voice Gateway for CLIR functionality, as well they don't know a theory how it should work. But they can show how to configure PBX for CLIR !!! :(
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...