Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to set the time in CCM5?

how to set time in CCM5?I find the time zone in Date/time group can't effect the accurate time displayed on the phone ? Do I need change the time on Linux admin ?

1 REPLY
Hall of Fame Super Red

Re: how to set the time in CCM5?

Hi Kannis,

Have a look at the following;

Use Date/Time Groups to define time zones for the various devices that are connected to Cisco CallManager. Each device exists as a member of only one device pool, and each device pool has only one assigned Date/Time Group.

Installing Cisco CallManager automatically configures a default Date/Time Group that is called CMLocal. CMLocal synchronizes to the active date and time of the operating system on the server where Cisco CallManager is installed. After installing Cisco CallManager, you can change the settings for CMLocal as desired. Normally, adjust server date/time to the local time zone date and time.

Note CMLocal resets to the operating system date and time whenever you restart Cisco CallManager or upgrade the Cisco CallManager software to a new release. Do not change the name of CMLocal.

From this doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a008037e960.html

Hope this helps!

Rob

Please remember to rate helpful posts.....

151
Views
0
Helpful
1
Replies