I have a site that has the following config: 2811 router, (2) 4-port FXO HWICs, (1) 4-port FXS/DID HWIC, and a 2-port T1 controller. This site has (4) POTS lines setup in a Trunk Group for PSTN access. How can i setup my fax machine so users can send faxes to it by 4-digit dialing?
I figured that I would have to take the fax line into an available FXO port and then connect the Fax machine to an FXS port. What would the Dial Peer look like in this situation?
I am assuming that your faxes on on your IPT netrwork. What protocol do you use to control them (MGCP, H323)?
If MGCP then you simply make sure that the CSS assigned to the FXS port has access to other FXS port paritions.
If it's H.323 then you need to configure dial-peers pointing to other fax machines and make the session-target ipv:, also make sure you use G.711 codec and wheater you want to use pass-through or relay by adding appropriate commands. Make sure the H.323 GW is configured on CCM.
SIP traces provide key information in troubleshooting SIP Trunks, SIP
endpoints and other SIP related issues. Even though these traces are in
clear text, these texts can be gibberish unless you understand fully
what they mean. This document attempts to br...
Please find the attached HTML document, download and open it on your PC.
This provides an easy to use form where you simply answer a few
questions and it will render the proper jabber-config.xml file for you
to copy/paste. There is built in logic to verif...
CUCM Database Replication is an area in which Cisco customers and
partners have asked for more in-depth training in being able to properly
assess a replication problem and potentially resolve an issue without
involving TAC. This document discusses the bas...