Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How To Show Active ISDN Calls with MGCP GW

Hello,

We recently migrated from CME to full CCM. We converted our old CME into a gateway for CCM.

Before, if I wanted to see the called/calling number on the gateway I could do a "sh isdn active" However, now that it's moved into CCM as an MGCP gateway, this doesn't work anymore. You can run the command, but it doesn't show anything.

You can do a "show voic call status", but this doesn't show the details of who's calling or being called.

CallID CID ccVdb Port DSP/Ch Called # Codec Dial-peers

0xE50E1 3A4D 0x65277580 1/0:23.23 2/2 * g711ulaw 0/0

0xE50F9 3A59 0x6567C2B4 1/1:23.19 2/1 * g711ulaw 0/0

0xE516B 3A92 0x65277580 1/0:23.18 4/3 * g711ulaw 0/0

0xE5181 3A9D 0x65277580 1/0:23.17 3/2 * g711ulaw 0/0

0xE5185 3A9F 0x65277580 1/0:23.16 3/5 * g711ulaw 0/0

0xE5199 3AA9 0x65277580 1/0:23.20 3/1 * g711ulaw 0/0

0xE51A7 3AB0 0x65277580 1/0:23.15 4/4 * g711ulaw 0/0

Any idea on how I can see who's calling whom?

Thanks,

Dave

6 REPLIES
Hall of Fame Super Gold

Re: How To Show Active ISDN Calls with MGCP GW

Perhaps "sh call active voice compact" works with MGCP ? Probably not.

So the right place to look is CCM I guess.

Re: How To Show Active ISDN Calls with MGCP GW

sho cal active voice would only give you the far end side numbers... Problem is MGCP gateway actually functions as an "extension" of the callmanager (unlike H.323 where a gateway is sort of a "fully qualified" PBX sending and receiving calls from another "fully qualified" PBX, the callmanager).

New Member

Re: How To Show Active ISDN Calls with MGCP GW

So, from all of this should I conclude that there's no way to see active calls on an MGCP gateway at a given time?

Thanks,

Dave

Bronze

Re: How To Show Active ISDN Calls with MGCP GW

I've been trying to figure out a command that lets you do this for years, and haven't been able to come up with anything.

Re: How To Show Active ISDN Calls with MGCP GW

you could do a debug isdn q931 that would show the calling and called number. It would however only show when the call is made or tore down. I think this is as close as your going to get on the router side without looking in callmanager traces.

New Member

Re: How To Show Active ISDN Calls with MGCP GW

Dear Friend,

Try to use the following command:

--GW#sh call active voice brief--

Using this command you go to view all calls active in your GW - incoming and outgoing calls.

Victor Correa Wiik

from SP-Brazil

3137
Views
9
Helpful
6
Replies