Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How to test new PRI outbound

How do I test a new PRI to make sure I can actually place calls outbound?

BACKGROUND:

We currently have 3 PRI’s installed on our 3660 for inbound and outbound calls. Last night I plugged a new PRI to make 4 and configured the 3660 like so:

controller T1 3/0

framing esf

linecode b8zs

pri-group timeslots 1-24 service mgcp

description Local T1

interface Serial3/0:23

no ip address

no logging event link-status

isdn switch-type primary-4ess

isdn incoming-voice voice

isdn bind-l3 ccm-manager

no cdp enable

I went in to call manager and added the route group:

Then added the gateway.

I basically mimicked the configs that were already in place.

Now that everything is configured how to I test that specific PRI?

2 REPLIES
Cisco Employee

Re: How to test new PRI outbound

Create a route pattern specific to your cell phone. For the Gateway or Route List select that pri you just added.

Re: How to test new PRI outbound

Hi,

You'll better create a new Routegroup with only that gateway and put that RG in a new Route List.

Then create a test pattern like 8855.! pointing to that new routelist.

just use a 2,3,4 or 5 digit number that is free to use...

362
Views
4
Helpful
2
Replies
CreatePlease to create content