01-17-2006 10:53 AM - edited 03-15-2019 04:00 AM
How do I test a new PRI to make sure I can actually place calls outbound?
BACKGROUND:
We currently have 3 PRIs installed on our 3660 for inbound and outbound calls. Last night I plugged a new PRI to make 4 and configured the 3660 like so:
controller T1 3/0
framing esf
linecode b8zs
pri-group timeslots 1-24 service mgcp
description Local T1
interface Serial3/0:23
no ip address
no logging event link-status
isdn switch-type primary-4ess
isdn incoming-voice voice
isdn bind-l3 ccm-manager
no cdp enable
I went in to call manager and added the route group:
Then added the gateway.
I basically mimicked the configs that were already in place.
Now that everything is configured how to I test that specific PRI?
01-17-2006 04:36 PM
Create a route pattern specific to your cell phone. For the Gateway or Route List select that pri you just added.
01-18-2006 01:26 PM
Hi,
You'll better create a new Routegroup with only that gateway and put that RG in a new Route List.
Then create a test pattern like 8855.! pointing to that new routelist.
just use a 2,3,4 or 5 digit number that is free to use...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: