how to transfer control sequence through cisco router
i connected a x.25 device through a cisco 2621 router and a serial0/0 module(WIC_1T).i can transfer usual characters to the x.25 device,but cannot transfer a control sequence like CTRL_A(0X01).I suppose the router filter it.how can i transfer a control sequence ?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.