I try to send message to IPPhone user by Push, problem is, sometime, user not available , out to lunch or cannot to hear the PUSH message incoming voice, so, I add the WMI in Execute to turn the lamp ON. The problem is how can I turn it OFF when user press any key or browse to message. Can anyone please help show me the XML for this solution.
PS. I try event appGainFocus to notify the server to push turn off lamb but it's seem stupid, becasuse the browser apper but then dail OFF WMI lamp.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...