07-02-2002 01:02 AM - edited 03-12-2019 07:34 PM
Kindly suggest how we can config ATA 186 such that a PSTN Call Landing at VOIP GW AS5300 can be forwarded to ATA 186 in the same VOIP Network. We can config Voip-dial-peer at VOIP GW but spl. config required to be done on ATA 186(similar to dial-peer POTS, may be using UserID or LoginID field????).
Would appreciate your kind reply.
Shailendra
07-02-2002 05:47 AM
Take a look at the page below. There is a section on Cisco ATA.
http://www.cisco.com/warp/public/788/voip/voip.shtml
Hope this helps,
-Mckee
07-02-2002 01:03 PM
You basically have to decide on both AS5300 and o9n the ATA186, which Voip Protocol are you going to use.
Once you determine that,
Under the VoIP dial-peer on the AS5300 you set the following things:
Destination-pattern
Codec
Session target
Session protocol
07-02-2002 10:37 PM
Thanks. I assume we need to just configure uid0 & uid1, Gateway IP, ATA IP/Mask/Static GW(defualt GW) and matching RX/TX/LBRCodec on ATA to allow Inbound & Outbound H.323 based Calls.
Thanks
Shailendra
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: