Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How we can Conf ATA186 to receive Call from PSTN via VOIPGW 5300

Kindly suggest how we can config ATA 186 such that a PSTN Call Landing at VOIP GW AS5300 can be forwarded to ATA 186 in the same VOIP Network. We can config Voip-dial-peer at VOIP GW but spl. config required to be done on ATA 186(similar to dial-peer POTS, may be using UserID or LoginID field????).

Would appreciate your kind reply.

Shailendra

3 REPLIES
Cisco Employee

Re: How we can Conf ATA186 to receive Call from PSTN via VOIPGW

Take a look at the page below. There is a section on Cisco ATA.

http://www.cisco.com/warp/public/788/voip/voip.shtml

Hope this helps,

-Mckee

New Member

Re: How we can Conf ATA186 to receive Call from PSTN via VOIPGW

You basically have to decide on both AS5300 and o9n the ATA186, which Voip Protocol are you going to use.

Once you determine that,

• Under the VoIP dial-peer on the AS5300 you set the following things:

• Destination-pattern

• Codec

• Session target

• Session protocol

New Member

Re: How we can Conf ATA186 to receive Call from PSTN via VOIPGW

Thanks. I assume we need to just configure uid0 & uid1, Gateway IP, ATA IP/Mask/Static GW(defualt GW) and matching RX/TX/LBRCodec on ATA to allow Inbound & Outbound H.323 based Calls.

Thanks

Shailendra

115
Views
0
Helpful
3
Replies
CreatePlease to create content