Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

howto simulate a pri on 2600

I have a 2651XM with a 1DSU-T1 and a WIC-2MFT-t1 and need to use either of these WIC's to simulate a PRI. I assume this is possible, but have not been able to find any info on it. The phone guys have asked if there was a way to get them a PRI to test remote office PBX's before they ship.

  • Other Collaboration Voice and Video Subjects
3 REPLIES
New Member

Re: howto simulate a pri on 2600

Are you using the with Call Manager or another IP PBX?

New Member

Re: howto simulate a pri on 2600

it is an avaya 8500, i believe

Silver

Re: howto simulate a pri on 2600

You can simulate a voice PRI on a 2600 as long as you have DSP resources. If you want to make voice calls through it, the easiest way is to use something like a NM-2V card with VIC-2FXS , the AIM-VOICE-30 DSP card and a VWIC-1MFT-T1 card.

The following config would work -

isdn switch-type primary-ni

network-clock-participate wic 0

network-clock-select 1 t1 0/0

controller t1 0/0

pri-group timeslots 1-24

interface serial 0/0:23

isdn switch-type primary-ni

isdn incoming-voice voice

isdn protocol-emulate network

dial-peer voice 1 pots

incoming called-number .

port 0/0:23

direct-inward-dial

dial-peer voice 2 pots

description - calls to PRI

destination-pattern 1...

port 0/0:23

prefix 1

dial-peer voice 3 pots

description - calls to FXS ports

destination-pattern 2...

port 1/0/0

we use these configs all the time in the lab as PBX simulators . You need a T1 cross over cable to bring up the interface -

1 ---- 4

2 ---- 5

4 ---- 1

5 ---- 2

126
Views
0
Helpful
3
Replies