when there are 2 routers with HSRP running (1 group for voice, 1 group for data) with each routers having its own PSTN (PRI) connection, can out going PSTN calls be configured to use both links on both routers? even though only one router will be the active router for the voice vlan?
Well.....even though you are using HSRP for redundancy for you hosts you will still configure the PRI on both routers. If you are using H.323 you will use one of the local IP Addresses on the router (not the HSRP address) to configure the gateway. If you are going to use MGCP you will use the hostname of the router as the MGCP Domain. There is no reason to not load balance across both PRI's if you are paying for it (or depending on how you have your Route Group set up one will be the secondary PRI)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...