I am trying to push application to the phones using CiscoIPPhoneExecute object. I can push to the phones successfully, however we need to confirm if the phones have recieved the push. To confirm, we are using CiscoIPPhoneResponse.
My problem is that this push and response works great on 7970 and 7905/11/12. However on 7960, I get an HTTP 303 error when I try to read the response from the phone (phone do get the alert though).
I ran the Ethereal to read the network traffic. I found that 7960 does Http redirect which causes http 303 error. So the exact same execute behaves differently on 7960 and all the other phones. I tried to change the phone load, but they all behaved the same on 7960.
the redirect is a normal part of the phone's behavior. when you send a CiscoIPPhoneExecute, the phone must first check to see if the username and password is valid. rather than make the reqestor wait, it sends a redirect to another page in the phone's web server, authenticates the supplied username and password against the authentication URL, and attempt to execute the CiscoIPPhoneExecute. the result of all this is posted on the page you were redirected to.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...